Category: Uncategorized
-
Final Project – Magic Mirror
This project was assembled and created by Brian Murithii and Tina Wong. Originally this project was supposed to be a generic coin sorter that can be found in almost every corner of Amazon. However, after much consideration for this project, we decided to move towards a more meaningful project and a more unique project. A…
-
Lab: Game or Audio Controller
Arduino Side Here is the basic setup of my breadboard. First I connected to the ground and power from the microcontroller and made sure it connected to the entirety of the board. Then I added the potentiometer and photocell to the breadboard. The potentiometer has signal, ground, and power. The signal of the potentiometer is…
-
Lab: Interactive Sensor “Box”
Part 1: Variable Input & Output For this part of the assignment, I had to use a potentiometer, a photocell, and two LEDs. However, I decided to do part 2 first, so that is why my potentiometer and photocell are connected by a breakout board. Anyway, the first thing that I had to do was…
-
Lab: Digital I/O
Part 1: Digital I/O with LEDs First, I had to test my board to check if it would follow the example code, Blink. I connected the power and ground of the microcontroller and then connected a resistor to pin 13. This will allow the code to read where the led is as it is related…
-
Lab: Basic Electronics
Part 1: Threadboard Circuits in Series and Parallel Series Parallel Part 2: Calculating Power Requirements Part 3: Breadboard Circuits in Series and Parallel Series 5. Button should light up once button is clicked. Parallel 5. LED should light up when switch is on.
Tina Wong 